wiTECH 1 / DRB III Enhanced Emulator Dealership Requirements

FCA requires the use of the wiTECH Diagnostic Application (wiTECH 1) to launch DRB III Enhanced Emulator for diagnostics on legacy bus ECUs and vehicles.  All dealerships should have at least one microPOD 2 with the first three serial letters WSP dedicated for use with wiTECH 1 / DRB III Enhanced Emulator.

The wiTECH Diagnostic Application (wiTECH 1) can be downloaded and installed on a Windows PC from DealerCONNECT (DealerCONNECT > Service > wiTECH Information (Under the SERVICE TOOLS & EQUIPMENT section) > Legacy Tools > wiTECH Software Installer).  Installation instructions are also found in this DealerCONNECT location.

For use of DRB III Enhanced Emulator, please see our YouTube Playlist on DRB III Enhanced Emulator.

For general diagnostic tool to vehicle year model reference, please see the article: Vehicle to Diagnostic Tool Reference Chart

For DRB III Enhanced Emulator requirements, see the article:  DRB III Enhanced Emulator

For a list of vehicles that require multiple diagnostic tools for diagnostics, see:  Vehicles Not Fully Supported with wiTECH 2.0

Attachments
There are no attachments for this article.
Related Articles RSS Feed
microPod Warranty Replacement
Viewed 3907 times since Mon, Apr 10, 2017
How-to Configure a Wireless Profile on a microPOD 2
Viewed 128882 times since Fri, Feb 5, 2016
Video - Knowledge Base did you know
Viewed 418 times since Wed, Apr 3, 2019
wiTECH Premium Support Helpdesk Contact Information
Viewed 10004 times since Wed, Sep 6, 2017
Steps to Associate microPods to Service Technician
Viewed 47108 times since Mon, Sep 29, 2014